Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Alternating current motor:
Use a shockproof plug, mains voltage 230 V with residual current circuit breaker and 10 A inert fuses.
•
Use connection cable or extension cable respectively with a cross section of at least 1,5 mm².
Check that the PRCD is operative: indicator panel red.
Press the green button ( I ) on the switch. At the same time, check whether the rotating direction
of the cutting-off wheel corresponds to the indicated rotational direction on the protection cover (arrow).
If there is a power cut, the machine switches off automatically. To restart, press the green button
again.
Switching off
Press the red button ( 0 ) on the switch.
WORKING INSTRUCTIONS
Before commencing work, ensure the following:
•
Workplace tidied?
•
Is the radial tile cutter stably mounted?
•
Check before starting to work whether the rotational direction of the cutting-off wheel agrees with the rotational direction
indicated by the arrow on the cover hood.
•
You may not start to operate the machine until you have read these operating instructions, observed all the instructions given
and installed the machine as described!
Working with the radial tile cutter
Keep your hands always in a safe distance to the rotating cutting-off wheel.
•
Do not start working before the cutting-off wheel has reached its maximum rotational frequency.
•
Pay attention to that the cooling water pump washes water to the cutting-off wheel.
•
Always use the stop supplied when cutting.
•
Only workpieces which have been securely mounted and aligned can be processed.
In any case, adhere to all safety notes (see "Safe working").
ADJUSTMENTS ON THE RADIAL TILE CUTTER
Carrying out angle cuts
Make sure the machine is switched off when performing adjustment tasks and push the saw head toward the rea
20
Daily checks of the PRCD (residual-current-operated circuit breaker)
The device must be connected via the residual-currentoperated circuit breaker (PRCD).
Perform this check once in a day.
When changing the location no further test is required.
1. Directly plug the PRCD into the outlet (vertical).
2. Press the "Reset" key – you will hear a click and the indicator panel will light up red.
3. To check the PRCD press the "Test" key. The inspection panel no longer shows any colour.
4. Press the "Reset key" again – the indicator panel will light up red again.
5. The machine can be started.
Switch on
Do not use any device where the switch can not be switched on and off. Damaged
switches must be repaired or replaced immediately by the customer service.
Werbung
Inhaltsverzeichnis
