Technical Specifications - Genius Mercury Bedienungsanleitung

ENGLISH
These instructions apply to the following models:
MERCURY - MERCURY C - MERCURY V - MERCURY C V
The Mercury automated systems are designed for automating
balanced industrial sectional doors.
They consist of an electro-mechanical operator, and either on-
board electronic control equipment (Mercury C) or an
interconnection board for a remote control equipment
(Mercury). Installation is possible either directly on the shaft of
the rope-winding drums, or by chain transmission (optional item)
with a reduction ratio of 1:1.5 or 1:2.
The non-reversing system ensures mechanical locking of the door
when the motor is not operating and, therefore, no lock needs
to be installed; the manual release and the manual opening
system (in models for which it is supplied) make it possible to
move the door in case of a power cut or malfunction.
The Mercury automated systems were designed and built for
indoor and outdoor use.

1. TECHNICAL SPECIFICATIONS

Power supply (Vac 50-60Hz)
Electric motor
Maximum absorbed power (W)
Absorbed current (A)
Starting capacitor (µF)
Winding thermal protection (°C)
Use frequency (S3)
Max number consecutive cycles
Power take-off Hollow through shaft diam. 25,4mm (1'')
Power take-off rotation speed (rpm)
Rated torque of power take-off (Nm)
Power take-off max revs
Protection class
Operating ambient temperature (°C)
Gearmotor max weight (Kg)
Oil quantity (l)
Note: consult Table 1 for chain transmission applications
AUTOMATED SYSTEM MERCURY
230 (+6 –10%)
single-phase induction 1450rpm
800
3,5
20
140
40%
5
23
50
24
IP54
-20 / +55
14
0,9
Table 1
Type of Rated
application torque
Direct
Reduction ratio 1:1.5
Reduction ratio 1:2
Graph 1 shows with which type of application the Mercury C can be installed,
considering the maximum force required to manually move the door F, in daN
(1daN = force required to lift 1,02 kg), and the diameter of the rope-winding
drum Df in millimetres. For example, if a door can be moved with a force of
60daN and the drum diameter is 170 mm, a Mercury C with chain transmission of
1:1.5 must be installed.
N.B. Force F can be measured with a dynamometer. It is not directly related to
the weight of the door, but to its balance.
Graph 1
Transmission
1:2
Transmission
1:1.5
Direct application
2. DIMENSIONS AND DESCRIPTION
10
Rope shaft
speed
(Nm) (rpm)
50 23
75 17,2
100 11,5
ENGLISH
Rope shaft
max revs
24
18
12
Fig. 1