LG F14WM12GT Bedienungsanleitung Seite 92

Symptoms
Door does not open
Wash cycle time delayed
Fabric softener overflow
Softeners dispensed too early
The buttons may not function
properly.
Dry problem
Odor
42
Reason
Once washing machine has
started, the door cannot be
opened for safety reasons.
If an imbalance is detected
or if the suds removing
programme is on, the wash
time will increase.
Too much softener may cause
an overflow.
Too much softener may cause
an premature dispensing.
The button cannot be
recognized when the door is
open.
Check water supply tap.
This odor is caused by
the rubber attached to the
washing machine.
If the rubber door gasket
and door seal area are not
cleaned regularly, odors can
occur from mold or foreign
substances.
Odors can occur if foreign
substances are left in the
drainage pump filter.
Odors can occur if the
drainage hose is not properly
installed, causing siphoning
(water flowing back inside the
washing machine).
Using the dry function, odors
can occur from lint and other
laundry matter sticking to the
heater. (Dryer model only)
A particular odor can occur
from drying wet clothes with
hot air. (Dryer model only)
Solution
• Check if the 'Door Lock' icon
is illuminated. You can safely
open the door after the 'Door
Lock' icon turns off.
• This is normal. The time
remaining shown in the display
is only an estimate. Actual
time may vary.
• Follow softener guidelines to
ensure appropriate amount
is used. Do not exceed the
maximum fill line.
• Follow the guidelines provided
by the detergent manufacturer.
• Close the dispenser drawer
slowly. Do not open the drawer
during the wash cycle.
• Press again after closing the
door.
• Do not overload. Check
that the washing machine is
draining properly to extract
adequate water from the load.
Clothes load is too small to
tumble properly. Add a few
towels.
• Turn off water supply tap.
• It is the normal odor of new
rubber and will disappear after
the machine has been run a
few times.
• Be sure to clean the gasket
and door seal regularly and
check under the door seal for
small items when unloading
the washer.
• Be sure to clean the drainage
pump filter regularly.
• When installing the drainage
hose, be sure that it doesn't
become kinked or blocked.
• This is not a malfunction.
• The odor will disappear after a
short while.
EN