Over Temperature - Briggs & Stratton P0820B Bedienungsanleitung

EN
AR BG CS DA DE
This will enhance the life of the battery.
Once it is fully charged, the next charge will
return to standard charging.
For best results, the battery should be
charged in a location with a temperature
between 6°C and 40°C.
1. Plug the charger into an AC power
outlet.
2. Insert the battery into the charger.
3. When the battery is fully charged,
unplug the charger and remove the
battery.
This is a diagnostic charger. The Charger
LED Lights (See Figure 3) will illuminate in
specific order to communicate the current
battery status. They are as follows:
Make sure the battery is fully inserted into
the charger before charging.
The battery will become slightly warm to
the touch while charging. This is normal
and does not indicate a problem.
CHARGING FAULT
When the battery is inserted into the
charger and the status LED blinks RED,
remove the battery from the charger for
1 minute, then reinsert. If the status LED
blinks GREEN, then the battery is properly
charging. If the status LED is still blinking
RED, remove the battery and unplug the
charger for 1 minute. After 1 minute, plug in
the charger and reinsert the battery. If the
status LED blinks GREEN, then the battery
is properly charging. If the status LED is
still blinking RED, the battery is defective
and needs to be replaced.

OVER TEMPERATURE

If the battery is inserted into the charger
when warm or hot, the CHARGING LED
indicator light on the charger may switch on
EL ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SV TR
English (original instructions)
and illuminate RED. If this occurs allow the
battery to cool inside of the charger for up to
30 minutes. Charging should automatically
start once battery has cooled.
STORAGE
■ Remove the battery and store it in a
cool dry location, if possible. Charge the
battery every two months when not in
use in order to increase its life.
■ Remove the battery and store in a secure
location out of the reach of children.
For battery storage longer than 30 days:
■ Store the battery where the temperature
is below 80°F and away from moisture.
■ Store battery in a 30%-50% charged
condition.
■ Every two months of storage, charge the
battery as normal.
To reduce the risk of electric shock,
fire, or serious personal injury, always
remove the battery when servicing or
transporting the powerhead.
SERVICE
Servicing requires extreme care and
knowledge and should be performed
only by a qualified service technician. For
service we suggest you return the product
to your nearest AUTHORIZED SERVICE
CENTER for repair. When servicing, use
only identical replacement parts.
3
WARNING