Yellowtec Intellimix Bedienungsanleitung Seite 19

Base Unit
The Base Unit: Back Panel
The Base Unit performs the DSP, audio I/O, and GPI/O.
The back panel of the BU is shown on the following pages with its
connectors.
The Mic 2 input can be Mic
or Line Level. Analog line
inputs and outputs are
always mono.
Line In/Out 1-2 are
2 symmetric analog
mono I/Os.
Multi I/O 1
Line out 5+
Analog Out 5 Line out 5-
SHIELD
HP 1 L
HP 1 HP 1 R
HP COM
36
Downloaded from www.Manualslib.com
Line 3/4 are for MADI GA1 and MADI
consumer level GA2 can receive opto
devices, such as a connectors for MADI
field recorder. extension.
Line in 3
Mic 2 Line in 1 Line in 2 Line out 1 Line out 2 Line in 4
USB provides 16 I/O AES3 interconnects a
channels: 8 stereo or 16 digital stereo source with a
mono. stereo destination.
1 9
1
2
9
10 Line Out 6+
11 Line Out 6-
GPO 1 3 SHIELD
GPO 3
GPO 2
7
GPO 4
8
15
81 5
+ or -
- or +
5DC
5 ... 30V
+ or -
- or +
5DC
manuals search engine
SPDIF/ADAT opto
connectors can be
configured to SPDIF I/O
or a multichannel ADAT
interface.
SPDIF/
Multi I/O 2
ADAT
Line out 3
MADI -2
in out
Multi I/O 1
AES3 in 1
Line out 4 MADI -1 PUC-16
APC 1 PoE port to interconnect
with PoE connector for the CU.
APC 2-4 are PoE connectors for
up to three optional channel I/O
extensions.
Multi I/O 2
AES3/EBU in 2+
Analog Out 6
Digital in 2 AES/EBU in 2-
SHIELD
AES3/EBU out 2+
Digital out 2 AES/EBU out 2-
SHIELD
E1/AoIP connects a PC
when configuring the BU,
or interconnects the
DANTE 4x4 interface.
SYNC In/Out
Sync Extension-1
APC 2A PC 4
AES3 out 1
E1/AoIP
APC 1 APC 3 PSU 1 PSU 2
PSU1/PSU2 takes the DC
input from the brick PSU. To
meet redundant PSU
requirements, use two PE
mounting tabs for proper
protective earth connection.
1 9
1
2
9
10 AES3/EBU in 3+
11 AES/EBU in 3-
4 3 SHIELD
5
12 13 AES3/EBU out 3+
14 AES/EBU out 3-
6 SHIELD
GPI 1
GPI 2
81 5
5DC 5 ... 24V
+ or -
- or +
Base Unit
PE Protective Earth
point for individual
connection.
Digital in 3
Digital out 3
37