Yellowtec Intellimix Bedienungsanleitung Seite 18

Dashboard
To assign a new entry to your Fab Four:
1. Locate the desired parameter in Settings.
2. Touch and hold the desired rotary element until the assignment
prompt appears. Only rotary elements can be assigned to the Fab
Four.
3. Select the position in the Fab Four to assign the new control.
This overrides the previous assignment at that position.
4. Navigate back by touching the Home button.
Assign this function to
Choose
Swipe and Touch
An arrow at the bottom of each channel display indicates that additional
settings are available beyond the Fab Four. Swipe over the arrow from
the bottom into the display to access the other settings. Scroll through
the section and select a parameter, which will be a rotary element or a
switch.
Touch a switch to toggle its value. The rotary elements zoom in when
touched. Use the rotary control (as described before) or touch and swipe
in a circle.
34
Downloaded from www.Manualslib.com
PGM1
rotary...
-20dB
manuals search engine
Arrows help navigate through the levels of parameter settings. Simply
spot them and try them out! Remember, if you ever get lost, press the
Home button.
MIC1
Swipe up from
below over
display frame
The Master Display
To keep things easy the master display within your dashboard works to
the same principles as the channel displays. The most obvious difference
is the replacement of the Fab Fours by a single circular bar to indicate the
level of your two monitoring outputs.
If not selected otherwise, the rotary is always assigned to work as
monitoring level control. Each output is controlled separately by toggling
the rotary for monitor or H/P. Hit the Monitor button to select the output
for control, levels will always be sustained. Assignment will be clearly
indicated by an icon.
PGM1
-20dB
Dashboard
Swipe down from
above over display
frame
PGM1
-20dB
35