Standard Accessories; Specifications - HIKOKI WH 14DBDL2 Bedienungsanleitung

English
Clockwise rotation
Counterclockwise rotation
Battery capacity
Remaining battery indicator switch
The battery remaining power is nearly empty.
Recharge the battery soonest possible
The battery remaining power is a half.
The battery remaining power is enough.
Tightening mode selector switch
Tightening mode indicator lamp
"Delicate work"
Tightening small diameter screws (M6 or
similar), etc.
"Normal work"
Tightening short screws, Affi xing plasterboard,
etc.
"Heavy load work"
Tightening long screws, coach screws, bolts,
etc.
Self drilling screw tightening
Warning
* Depending on attached battery. The heaviest weight is
measured with –
– BSL1450 for [WH14DBDL2]
– BSL36B18 (sold separately) for [WH18DBDL2]
Before
charging
While charging Lights
Charging
complete
Pilot lamp
(red)
Overheat
standby
Charging
impossible
Table 1
Indications of the pilot lamp
Lights for 0.5 seconds. Does not light for 0.5
Blinks seconds. (off for 0.5 seconds)
Lights continuously
Lights for 0.5 seconds. Does not light for 0.5
Blinks seconds. (off for 0.5 seconds)
Lights for 1 second. Does not light for 0.5
Blinks seconds. (off for 0.5 seconds)
Lights for 0.1 seconds. Does not light for 0.1
seconds. (off for 0.1 seconds)
Flickers

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed on page 236.
Standard accessories are subject to change without notice.
APPLICATIONS
Driving and removing of machine screws, wood screws,
tapping screws, etc.

SPECIFICATIONS

The specifi cations of this machine are listed in the Table on
page 236.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1- second intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger as shown in Fig. 2
(on page 237).
<UC18YFSL>
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in
red.
When the battery becomes fully recharged, the pilot lamp
will blink in red. (At 1-second intervals) (See Table 1)
● Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or the
rechargeable battery.
6
Battery overheated.
Unable to charge.
(Charging will
commence when
battery cools)
Malfunction in the
battery or the charger