Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Now connect the 4-pin plug of the cable coming from the mounting bracket and power supply of your
EN
ceiling fan (E2) to the input cable of the remote control (E1).
Then connect the 4-pin connector of the cable coming from the ceiling rod of your ceiling fan (A2) to the
output connector of the remote control receiver cable (A1) as shown in Fig. 3.
Do not mix them up, otherwise your fan will not function.
Check again that no cables have been damaged or crushed.
Do not connect the black antenna cable (X). It is used to transmit the radio signals.
Fig. 3
(A1)
(A1)
Positioning of the remote control for Vortice ceiling fans of the NORDIK series
Carry out the electrical connection according
to the wiring diagram opposite. With the Vor-
tice ceiling fans of the NORDIK series, the
receiver unit is simply inserted into the upper
canopy (Fig. 4) after the electrical connection.
Insert the antenna cable into the canopy.
Then secure the canopy against slipping
down in accordance with the operating in-
structions for the ceiling fan.
12
(A2)
(A2)
(E1)
(X)
(E1)
Receiving unit
Downrod
Canopy
(E2)
(E2)
Fig. 4
Canopy
Werbung
