Advanced Settings - Velleman VWS2 Handbuch

8. Advanced Settings

1. Network setting: check with your network administrator or
Internet service provider.
2. IP Get Method: the default setting is Static IP.
3. I/O Port Setting: select video input device. Our DVR1A,
DVR4QA, DVR4MQA and DVR16M are supported.
4. Device ID: enter the device ID for remote controlling.
5. Enable ALARM / DURATION: 9 durations are available:
10, 20, 30sec ; 1, 2, 3, 5, 10, 15min.
6. Mail setting: when the alarm is triggered, the video server
will e-mail the current picture to the assigned recipients.
7. Account Management: add/remove users and set authority.
8. Firmware Upgrade: to download firmware updates from the
FTP site and save it in the flash memory of the VWS2.
9. System Utility: setup maximum number of online users and bandwidth.
10. Apply: after a setting is changed, press "apply" to refresh the data in the VWS2.
11. Reboot: to restart the VWS2.
9. Dynamic IP Setting
a. Router Setting
The values vary from router to router - first read its manual.
1. Connect PC and router to the VWS2 and switch everything on.
2. Click Start (> Settings) > Control Panel (> Network and Internet
Connections) > Network Connections, double click 'Local Area
Connection', click 'Properties' , select 'Internet Protocol (TCP/IP)'
and click 'Properties'. Select "Obtain an IP address automatically".
3. Confirm and close the open windows. Open your browser and enter the default IP address (192.168.123.254) in
the address line. Then enter the login web page and enter the default password "admin" (on the left).
4. Click Basic Setting > Primary Setup > Change and change the router internet setting.
Choose "PPP over Ethernet" and click "Save" > "Reboot".
V WS 2 4