Velleman VWS2 Handbuch Seite 2

4. Static IP Setting
1. Connect the VWS2 (LAN connection - fig.1 #3) to your PC/notebook by means of the enclosed CAT5 cable and
switch your PC and the VWS2 on.
2. Click Start (> Settings) > Control Panel (> Network and Internet Connections) > Network Connections, double
click 'Local Area Connection', click 'Properties' , select 'Internet Protocol (TCP/IP)' and click 'Properties'.
3. Write down the original settings in order to restore them after the setup.
4. Set the IP address to "192.168.1.xxx" (xxx can range from 2 to 254). Set the Subnet mask to "255.255.255.0".
5. If applicable: click Start (> Settings) > Control Panel > 'Network and Internet Connections'/'Internet options' (> Set
up or change Internet connection), select the 'Connections' tab and click 'LAN settings' > disable Proxy Server.
6. To configure the server IP, double click the "Video web server" icon.
7. Enter user name, password (both default "admin") and IP address (192.168.1.1, port: 80) and click OK to connect.
8. When you see the control bar, you have successfully logged into the Video Web Server application program.
Click "System Config" to set up the Network setting.
Get your IP address from your internet service provider.
To add a new user, click "Account Management".
The maximum length of a user name or password is 8 characters.
The user levels are:
S: control all functions
A: control advanced functions
B: control basic functions only
After the setup, click "Apply" to confirm the information.
9. Connect the VWS2 (fig. p.1 #3) with the ADSL or cable modem to allow operation from the internet.
5. Connect via the Internet
1. Double click the "Video web server" icon.
2. Enter user name, password and IP address (the one you entered in §4 #8) and click OK to connect.
You can use the 'Address Book' button to choose a user name etc. used earlier.
3. When you see the control bar and a video image, you have successfully logged in.
V WS 2 2