QIMMIQ GOGGLE RACER Schnellstartanleitung Seite 10

Monitor Parameters
Size: 7 inch
Resolution: 1280x720
View Angle: 72° HD full view
Weight: 478g
Optical lens:3X
Battery: lipo 7.4V 1300mAh
Button function description:
SOURCE: Signal switch, HDMI/AV 1/AV2
UP/DOUM: Turn to selection key of menu
VOLUME: No enter menu voice adjustment key/ Enter menu voice adjustment key
MENU: Menu enter or esc key
lntegration receiver parameter:
32CH 5.8GHz video receiver
Antenna port:external thread inner needle (Use internai thread inner needle) Section 8 digital display
Sensitivity: -85dBm
Multifunctional connector: can support both power cord and audio interface
Frequency point:32 Frequencies :
Band 1: 5865,5845,5825,5805,5785, 5765, 5745,5725
Band 2: 5733, 5752, 5771,5790, 5809, 5828, 5847, 5866
Band 3: 5705, 5685, 5665, 5645,5885, 5905,5925, 5945
Band 4: 5740,5760, 5780, 5800, 5820,5840,5860,5880
Channel switch methods :
1.
point well for the first time, it will directly link the original frequency point instead of automatically
searching. )
2.
the current frequency group, the number it shows means the group of current frequency (Band 1-4),
short press the small button means switch channels (From 1-8)
3.
to auto search status.
Operation Instruction :
Power on, light turn on, press SOURCE key, switch to HDMI/AV1/AV2 signal.
1.
FPV input: switch display to AV1, receiver auto search frequency point. If there are several
transmitter, you can not search the related transmitter, switch channel via hand.lmages showed
after right frequency point. Use key to chose the effect of image you would like to.
2.
Video audio input: Switch display to AV2, external equipment (Such as DVD, MP4
etc)composite video signal and analog sound signal are input to FPV glass port via AV cable, images
are displayed in FPV, you can also hear the sound. Use key to chose the effect of view you would like
to.
3.
HDMI video input: switch display to HDMI, external HDMI device connect to HDMI port via
HDMI cable, you can see the HD video via window. Use key to chose the effect of image you would
like to.
4.
This FPV display does not support 30 video input.
Battery
You can powerthe GOGGLE RACER with a 2S Li-Po battery. A 2S 1P 1300Ah battery is included. The power connector is
2.1mm barrel plug- center pin positive.
The included wall charger is automatic and will shut off when charging is completed - indicated by the red LED
turning green. The GOGGLE RACER battery has a over-charge/overdischarge and balance protection circuit. If the
Auto search frequency point when power on. ( After setting the frequency
Long press the small button of the screen,the display flicker and reminder
Long press the small button of the display, circle from Band 1-4,then turns
11