ZAMST A1 Gebrauchsanweisung Seite 3

4.
Fasten the stirrup strap.
Stirrup strap
5.
Pull the dual inversion control strap to fasten it to the product.
The effect of the dual inversion control strap varies depending on which direction you pull it.
Non-stretchable
strap
6.
Fasten the strap bearing with the logo.
Inner side view (big toe side)
①
7.
Make sure that the product is not loose or out of place. If you feel any discomfort, repeat the steps from the beginning to
reattach the product.
The product correctly fastened (right foot)
<Front view>
Disclaimer:
* The product specifications and appearance are subject to change without notice for the purpose of improvement.
* When disposing of this product, be sure to follow all disposal ordinances and regulations as specified by the local government.
* We take all possible measures to ensure product quality, however, if you find any defects, etc. in our products, please contact Nippon Sigmax Co., Ltd.
"ZAMST" and "ZAMST logo" are trademarks or registered trademarks of Nippon Sigmax Co., Ltd in Japan, the United States and other countries.
① When the strap is pulled diagonally
upward:
Stretchable
strap
① When the strap is pulled diagonally
upward: Inversion is restricted
because the non-stretchable strap is
contracted.
②
③
Strap bearing
the logo
<Inner side view>
With your feet on the floor, pull the stirrup strap up to an extent
that it does not sag, fasten the strap to the product, and apply
firm pressure to the hook-and-loop fastener.
* Do not pull the strap up with excessive force as doing so
may cause skin and/or circulatory problems.
② When the strap is pulled laterally
(inward):
Stretchable
strap
Dual inversion
control strap
② When the strap is pulled laterally
(inward): Side-to-side instability is
restricted because the stretchable
strap is strongly elongated.
Wrap the strap bearing the logo around your ankle (①), pass it
through the loop (②), fold it back, and fasten it (③).
* Do not overtighten the straps as doing so may cut off blood
circulation to the foot or lead to skin and/or circulatory
problems.
<Back view>
Dual inversion
control strap
* In the illustration, the logo is facing
frontward. The logo does not always
come into the center. Its position may
differ according to the individual user.
* Adjust the strap bearing the logo as
necessary to ensure a snug fit.