ThinkFun Roller Coaster Challenge Anleitung Seite 4

5. For any Challenge that contains one or two Tunnels, your completed
Roller Coaster must pass under the Tunnel(s).
6. Each Track can only fall and cross a specified number of units. See
"Track Piece Geometry" on page 4.
7. The Loop Track must always rest on the Support piece, as outlined on
page 10.
Buckle up and get ready to twist and turn your mind in every way
possible as you attempt to solve 40 exhilarating roller coaster challenges.
Then... when you're ready for a little free-form play, get creative and use
the tracks to build your own elaborate gravity-defying thrill rides!
OBJECT:
For each Challenge, use all the Tracks and Posts shown on the
card to build a Roller Coaster that will carry your Car from the Start Track
to the End Track.
SETUP:
1. Select a Challenge Card.
2. Place the Posts as shown on the Card. The numbers on the Post icons
indicate how many pieces to stack. Attach a Curved Track piece in the
correct color to the top Post piece in the position shown, with the track
angled downward.
SETUP:
1
7
6
Start
ADD TO GRID:
End
3 5
EASY
EASY
Example: A Post icon with the number "3" indicates
that you should build a Post "3" pieces high.
Add to Grid
6
NOTE: It is possible to put more than one Curved Track on the same
Post stack. If this is part of a Challenge set-up, it will be shown like this:
3. Next, place the Tracks on your Grid to match the Challenge Card (if
shown). Make sure you have selected Tracks with the same number of
dots as shown on the Challenge Card.
The two dots shown on the blue Track indicate the Track
3
2
1
1 2
spans two grid spaces across.
4
3
2
1
7