Scottoiler eSystem Gebrauchsanleitung Seite 4

System Menu
Scottoiler offer an additional reservoir called "Traveller" that is compatible
with the eSystem. The Traveller additional reservoir increases the oil capacity
of the system. To keep the oil level indicator accurate it is possible to 'add-on'
this reservoir. The standard screen will show 'eSystem Only' meaning there are
no additional reservoirs in use. By pressing the SET button you can select the
eSystem + Traveller to let the eSystem know its new capacity.
When an additional reservoir is in place the oil level gauge will display
L
the overall capacity of the system. When both the eSystem reservoir
and the additional reservoir are full the oil level should be set to 100%.
Oil Level Menu
The oil level menu allows you to set the quantity of oil present in the reservoir.
By pressing the SET button the reservoir bar will fill from 0% to 100% in 20%
increments. The eSystem knows the quantity of each oil drop and the reservoir
volume therefore can keep track of your oil level and inform you when it is
running low. When the reservoir level is 0% (i.e. empty) the system will stop to
protect the pump.
Every time the eSystem reservoir is refilled or topped up the reservoir
L
menu must be set to 100%.
Sensitivity Menu
The eSystem has an internal threshold that corresponds roughly to speed that
is used to switch the unit into 'oiling' mode. The eSystem should switch to this
mode between 20 – 30mph. On smooth motorcycles the unit might not switch
mode until higher speed. In this case the oiling threshold speed can be altered
from this menu. The default is level 4 but if you need to lower the switching
speed then press SET to cycle to a lower number. If you need to raise the
switching speed then press SET to cycle to a higher number.
Do not to lower the threshold to a level where it will start oiling before
L
the motorcycle starts to move.
Boost / Prime Menu
The prime menu allows you to run the oiler at a high rate to prime the oil
delivery tubing. When SET is pressed the system will prime for 5 minutes.
Priming can be stopped at any time by pressing the SET button again. Prime
will only function if the reservoir is not empty and the Oil Level Menu shows at
least 1 bar.
The prime setting is usually only required on first installation but can also be
used to remove air bubbles from your oil line and to test the eSystem when
stationary.