Tower Mounting - Tripp Lite BP Serie Bedienungsanweisungen

Suggested Tower Installation
(for 2U Models Only)
1) On one side of your battery pack, connect
one mounting ear (A) to the Battery Pack's
four front mounting holes and another
mounting ear (B) to the four rear mounting
holes, using four screws and flat washers
(C) with each ear. The ends of the mount-
ing ears should stick out on opposite sides
of the Battery Pack.
2) Have one or more assistants lift the Battery
Pack and hold it in position until this step
is complete. Move the Battery Pack to its
intended floor space and hold it so that the
mounting surfaces of its ears (D) are level
with the floor. Bolt the ears to the floor
with two screws and flat washers (user
supplied, E) each. Without bolting the
Battery Pack in position, there is a danger
of tipping.
Your Battery Pack may be positioned safely in an
upright position without mounting screws with
the addition of Stabilizer Feet (part #300842),
sold separately from Tripp Lite.
6
Downloaded from www.Manualslib.com manuals search engine
Figure 1 (2U Tower)
Figure 2 (2U Tower)