Suggested Rackmount Installation For 2U Models In 2-Post Enclosures; Wall Mounting - Tripp Lite BP Serie Bedienungsanweisungen

Suggested Rackmount
Installation for 2U Models
in 2-Post Enclosures
1) On both sides of your Battery Pack, con-
nect one mounting ear (A) with four screws
and flat washers (B) to the Battery Pack's
middle four mounting holes. The mount-
ing surface of the ear should face the front
of the Battery Pack.
2) Have one or more assistants lift the Battery
Pack and hold it in position until this step
is complete. Insert the Battery Pack into its
intended rack space, until the mounting
surfaces of its ears (C) meet the outside of
the rack's rails (D). Connect the mounting
ears to the rails with two screws and flat
washers (user supplied, E) on each side.
Suggested Wall Installation
(for 2U Models Only)
1) On both sides of your Battery Pack, con-
nect one mounting ear (A) to the Battery
Pack's four front mounting holes and
another mounting ear (B) to the four rear
mounting holes, using four screws and flat
washers (C) with each ear. The mounting
surfaces of the ears should face up and out,
and the bottom of the ears should be flush
with the bottom of the Battery Pack.
2) Have one or more assistants lift the Battery
Pack and hold it in position until this step
is complete. Move the Battery Pack to its
intended wall space and hold it so that the
mounting surfaces of its ears (D) are pressed
to the wall. Attach the ears to the wall with
two screws and flat washers (user sup-
plied, E) each.
Downloaded from www.Manualslib.com manuals search engine
Figure 1 (2U 2-Post)
Figure 2 (2U 2-Post)
Figure 1
(2U Wallmount)
Figure 2 (2U Wallmount)
OR
5