ASROCK 880GM Pro3 Handbuch Seite 23

Downloaded from www.Manualslib.com
2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors 2.8 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
Serial ATA3 Connectors
(SATA3_1 (PORT 0):
see p.2, No. 18)
(SATA3_2 (PORT 1):
see p.2, No. 17)
(SATA3_3 (PORT 2):
see p.2, No. 16)
(SATA3_4 (PORT 3):
see p.2, No. 15)
(SATA3_5 (PORT 4):
see p.2, No. 14)
Serial ATA (SATA)
Data Cable
(Optional)
USB 2.0 Headers
(9-pin USB10_11)
(see p.2 No. 11)
(9-pin USB8_9)
(see p.2 No. 10)
(9-pin USB6_7)
(see p.2 No. 9)
ASRock
manuals search engine
These five Serial ATA3
(SATA3) connectors support
SATA data cables for internal
storage devices. The current
SATA3 interface allows up to
6.0 Gb/s data transfer rate.
Either end of the SATA data cable
can be connected to the SATA3
hard disk or the SATA3
connector on this motherboard.
Besides four default USB 2.0
ports on the I/O panel, there are
three USB 2.0 headers on this
motherboard. Each USB 2.0
header can support two USB
2.0 ports.
880GM Pro3 Motherboard
23 23 23
23 23