Connection - THOMSON CKT620FD Einbau- Und Betriebsanleitung

EN 1 1 / / INSTALLING YOUR APPLIANCE
• •

CONNECTION

These hobs must be connected to the mains
using a socket in compliance with publication
CEI 60083 or an all-pole circuit-breaker
device in compliance with the installation
rules in force.
When power is first supplied to your hob, or
after an extended power cut, an indicator
light will appear on the control panel. Wait for
approximately 30 seconds until this informa-
tion disappears before using your hob (This
display is normal and it is intended, if applica-
ble, for your after-sales service. In all cases,
the user of the hob should disregard it).
Warning
If the cable is damaged it must be
replaced by the manufacturer, its after-
sales service or a person with a similar
qualification to prevent danger.
• Connection of 220-240V
Blue
Brown
32A
Blue
Brown
16A
Downloaded from www.Manualslib.com
~
Black
Green/yellow
N N L L
Green/yellow
N N L L
manuals search engine
• Connection of 400V 2N
Separate the 2 phase wires (L1 and L2) before
connection.
Black
Brown
Blue
L L 1 1 L L 2 2
N N
N N e e u u t t r r a a l l
P P h h a a s s e e
For a 400 V 2N triphase connection, if your
hob malfunctions, check that the neutral
conductor is properly connected.
• Connection of 2x230V 2L+2N
Separate the wires before connection.
Black
Brown
Blue
N N 1 1 N N 2 2
N N e e u u t t r r a a l l
• Connection of 400V 3
20
- 16A
~
Green/
yellow
E E a a r r t t h h
- 16A
~
Green/
yellow
L L 1 1 L L 2 2
E E a a r r t t h h
P P h h a a s s e e
- 16A
~