Bosch DWK09M760B Montageanleitung Seite 30

Installation
Lay the chimneys on the hood in such a
way that the side tangs are inside the
chimney and the front tang is outside (in
order to lock the chimney in position).
Pull the upper section upwards and fix it
above to the chimney support bracket
with 2 screws (12).
12
Warning! If the hood has to be used in
extractor version, remove, if supplied, the
carbon filter and the fastening wand
(placed on the back of the grease filters –
see relative paragraph).
30
Downloaded from www.Manualslib.com
12
manuals search engine
If the hood has to be used in filtering
version, make sure that the carbon filter is
already mounted on the back of the
grease filter, or in case it's missing, buy it
and install it.
• Reinstall the grease filters and close the
panel.
Note - only for installation without flues: if
you want to use the hood in the filtering
version, install the small grills/deflector on
the flanges.
Note: install the small deflector grills so that
the air is conveyed to the side opposite the
wall.