Operation Of Your Classic Preamp; Power On - Nagra CLASSIC PREAMP Bedienungsanleitung

OPERATION OF YOUR CLASSIC PREAMP

__________________________________________________________
Proceed only if you have completed the installation steps as
described in the previous chapter INSTALLATION OF YOUR CLASSIC
PREAMP.

Power On

To use your preamplifier, you must push the mains power switch to
position 1 (ON) first. The mains power switch is located on the rear
panel (please see page 32)
The typical Nagra rotary selector offers 4 positions.
This table sums up the different positions vs. actions.
Mains switch
0
I
I
I
I
OFF: similar to STANDBY. The unit is
still powered but the consumption
remains very low.
R: is for Remote Control use.
MUTE: the unit is turned on but the
signal is muted. No sound.
ON: the unit is playing normally.
Nagra selector
Any
OFF
R
MUTE
ON
34
NAGRA – CLASSIC PREAMP
Action
The unit is switched off
The unit is in standby
The unit can be triggered
on and off remotely
The unit is on and muted
(for warming
instance)
The unit is playing
up for