Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GENERAL INSTRUCTION
Read carefully the instructions given in this booklet. Before connecting the appliance make sure that the data
shown on the technical plate (Fig.1), corresponds with that of the mains power supply. Before carrying out
any operation, insulate the appliance from the mains power supply. The installation must he carried out by
professionally trained personnel in accordance with the instructions of the manufacturer and current
regulations.
The Manufacturer declines all responsability for:
any damage resulting from ignoring the instructions for installation and use or from irregular use of
the appliance;
any inaccuracies contained in this booklet due to copying or printing errors.
The Manufacturer reserves the right to make alterations thought useful to the product, without changing its
basic characteristincs.
THECNICAL DATA
Dimensions
mm
Power
W
Power supply
Net weight
Kg
INSTALLATION INSTRUCTIONS
1. The identifying and technical plate is fixed to the bottom of the appliance (Fig.1).
2. Remove the protective film from parts before using the appliance.
3. ELECTRICAL SAFETY RULES
Please observe these essential rules:
the mains voltage and that on the technical plate must be the same;
connection must be to a regulation earthed socket;
connection must be to an equipotential system.
4. ELECTRICAL CONNECTIONS: must be carried out by trained personnel in accordance with electrical
norms. The power cable must be positioned so that no part of it reaches a temperature by 50°C. Before
installation make sure that the socket or switch used can be easily reached when the apliance is in place.
CAUTION: PRODUCER DECLINE ALL RFSPONSABILITY IF THESE SAFETY RULES ARE NOT
OBSERVED.
INSTRUCTION FOR USE
1. The appliance is intended for collective use and must be used by properly trained personnel.
2. Before switching on the machine for the first time, thoroughly clean off the industrial oils.
● Starting up
1. Put the plug into the power socket and turn on the main switch (A fig.2).
2. Turn the thermostat (B fig.2) until the temperature setting required is reached. The heating light (C fig.2)
will come on and will go off when the set temperature is reached.
3. Now the appliance is ready to be used.
● Turning off
1. Put the thermostat (B fig.2) into position "0", and check that the light (C fig.2) to go off.
2. Turn off the main switch (A fig.2).
3. NOTE: if the plug remains inserted the appliance is still live.
PV50
500 x 500 x 70h
600
230V/1N/50-60Hz
7,10
4
PV100
1000 x 500 x 70h
1200
230V/1N/50-60Hz
14,00
Werbung
Inhaltsverzeichnis
