Activating And Setting The Date/Time; Attaching The Unit - uebe visomat handy Gebrauchsanleitung

C

5. Activating and setting the date/time

The unit has a date/time function which you can activate where necessary. This
function is deactivated when the unit is delivered.
Activating the date/time function
To activate the date/time function, press the Start/Stop button and then
immediately, while the full display is visible, the Memory button. This function can
be deactivated at any time in the same way.
Setting the date/time
The four-digit number representing the year appears in the
display first (Fig. 1). Press the Memory button to set the year.
Press the Start/Stop button to confirm the selected year and
proceed to setting the date.
Set the month with the Memory button and confirm this with the
Start/Stop button. Set the day, hours and minutes in the same
way (Fig. 2, Fig. 3).
Changing the date/time
To change the date/time function, take out a battery and wait
until the display goes blank. Now you can reactivate the date/
time function and reset the date and time again.
Deactivating the date/time function
To deactivate the date/time function, press the Start/Stop button
and then immediately the Memory button.
When the date/time function is activated, the time is also shown
in the display when the unit is switched off.
EN-36
Operating the unit
Fig. 1
Fig. 2
Fig. 3
Operating the unit

6. Attaching the unit

The special double-preformed comfort cuff is easy to attach and provides for a
perfect fit during measurement. The materials used have been tested for skin
compatibility in accordance with ISO 10993.
• Expose your wrist, with the palm of your hand facing
upwards.
• Slide the unit over your wrist. Make sure the gap
between your wrist and the top edge of the cuff is
approx. 1 cm.
• Now pull the free end of the cuff tight and close the
cuff with the Velcro-type fastener.
Thanks to its optimised shape, the cuff fits very tightly to
prevent measurement errors.
C
EN-37