Werbung
Verfügbare Sprachen
Verfügbare Sprachen
19
18
17
16
INDIVIDUAL INPUT CHANNELS
Unless otherwise noted, this section will describe the features found on each and every input
channel. All channels are identical except for the absence of Polarity Switches on the last two
channels on each bank of eight. The Channel section is divided into three sub-sections: Input
Patching, Filtering/EQ, and Monitoring/Controlling. Let's begin at the top of channel 1 (top-left
side of the board) and work our way down.
Input Patching
This section will describe the Input/Thru connections for each channel along with the Pad, polarity,
Insert, and Input Gain features.
20. Channel Input/Thru: This input is a true transformer balanced female XLR input for low-
impedance sources such as microphones. For high-impedance sources it is recommended to use a
direct box before connecting to the input. A 20 dB pad (#22) is provided for high level sources. Pin 2
is the positive input pin so you will want to make sure this is compatible with your outboard source.
The Thru XLR is a parallel connection (or split) to send the source signal to the Mains (FOH —
Front of House) mixer. This is typically done via an audio snake such as the Peavey Audio Link.
Downloaded from
www.Manualslib.com
16. Headphone Output: This stereo jack (TRS) provides the signal to
drive stereo headphones. No signal is heard until either AFL (#13) or PFL
(#41) is selected on an active Master Monitor output. If both AFL and
PFL are selected simultaneously from the same output, the PFL signal
will be heard. The stereo jack is wired: Tip=Left, Ring=Right, and
Sleeve=Ground.
17. Headphone Level: This control adjusts the level of the Headphone
Output (#16). This includes the PFL level when it is active.
18. Wedge Level: This control adjusts the level of the Wedge Output
(#54). This includes the PFL level when it is active. The Wedge Left/Right
signals are the same signals found in the headphones. This level control,
however, gives you separate control over the Wedge Output level and is
not dependent of the Headphone Level control.
19. Master PFL Level/LED: This section adjusts the level of the PFL
mix found at the Headphone and Wedge Outputs. A channel's PFL
Switch (#41) must be selected in order for the PFL Level control to work.
This is indicated by the LED above the Master PFL Level control. If this
LED is pulsating off and on then it is a clear indication one of the channel
PFL switches are on.
manuals search engine
8
20
20
Werbung
