Kerbl Digitale Hängewaage 1000 Bedienungsanleitung Seite 23

• ZERO
Operation
0
• TARE
Operation
TARE
• Battery Checking
Press OFF/ON on scale the voltage U 6.30 was shown. Normally, battery voltage should be higher than 5.8V.
• Weight Holding
Press "HOLD" key on controller display. After reading is stable, HOLD ights on. Press HOLD again, to resume the reading.
• LOW Power WARNING
When the battery voltage is lower than U 5.80, the display will flash, but the scale can still work until -Lb-shows up,
followed with automatic power off in 1 min. Battery recharging is needed.
• OVERLOAD WARNING
OL shows up when weight (Net + Tare) exceeds total capacity + 45 g. For safety use, do not overload the scale.
• POWER SAVING
( - ) Shows up when no weight is changed over 15 min. It resumes when weight changes, and powers off automatically
when no weight is changed over 60 min.
• RECHARGING BATTERY
1. Turn off the scale, connect the adapter to 220V AC power supply, and plug its connector into the socket in the rear of
scale. When the indicator turns from green to red, charging is over.
2. If the scale needs to work non-stop, take off the dead battery and replace it with a full one. The dead one can be
recharged separately.
ATTENTION: Normally, recharging time should not exceed 8 hours. With charging protection, however, long time char-
ging will not damage the battery.
• TURN OFF
Press OFF/ON scale for 3 seconds U 6.30 (Battery voltage displayed).
Illustration
"0"shows up after turning the scale on. If the scale shows
another value please press ZERO on scale.
display for the total capacity
display for the actual voltage
wait for stable signal
„STB" flashed up, unit is ready
Illustration
After hanging up weight, press TARE to subtract the tare.
while xxxx lights on, scale works in net mode.
display for the total capacity
display for the actual voltage
wait for stable signal
„STB" flashed up, unit is ready
23
Display
e g. 10/20
e g. 30000
e g. U 6.30
- - - - -
0
Display
e g. 120/130
e g. 30000
e g. U 6.30
- - - - -
0