Maytag NEPTUNE MDE7550AGW Benutzerhandbuch Seite 9

S T
ETTING A IME
If there are no words on the touchscreen, open the door, touch any pad (except OFF), or touch the screen to "wake" the
controls.
Home
timed dry freshen up
sensor dry crease removal
air fluff
favourites
(no heat)
Step 1
Select "Timed Dry" setting. The
next screen will be the Review
Screen. If the selections are correct,
press Start/Pause. If changes need
to be made, follow the next steps.
Press "Start/Pause" or
change your selections below.
options
timed dry
end chime medium
45 minute(s)
temperature
medium
Step 4
Review Screen – This screen
reviews your selections
starting the dryer, and allows you to
choose options to further customise
your dry programme. You may press
Start/Pause to begin drying, or
press a displayed choice to change
previous selections.
Remember: As you use the touchscreen, if you feel you are lost, press Back or Home.
Downloaded from www.Manualslib.com
D P
RY ROGRAMME
change your selections below.
time
45 min
minute(s)
temperature
medium
Step 2
Time – Press the "Timed Dry" area
to adjust the number of minutes to dry
the load (default is 45 min.) Press the up
and down arrows to set the time. The
time will increase or decrease in one-
minute increments. Press "Continue"
when the desired time is selected to
return to the review screen.
crease prevent
reminder chime
Step 5
Options Screen – There are three
before
option choices available, touch each option
to select or deselect it:
• "Crease Prevent" - Intermittent
tumble in room temperature air for up
to two hours following the dry
programme.
• "Reminder Chime" - Chimes at the
end of the programme every 5 minutes
for up to two hours.
• "End Chime" - Chimes once when the
selected dryness level is reached.
manuals search engine
Press "Start/Pause" or
Time
options
programme chime medium
45
continue
Options
end chime
medium
continue
8
Press "Start/Pause" or
change your selections below.
Temperature
options
time
programme chime medium
45 min
high medium
temperature low extra low
medium
Step 3
Temperature – Select the appropriate
temperature setting for drying the load.
Step 6
If you are satisfied with the selections,
press the Start/Pause touchpad to begin
the programme.