Maytag NEPTUNE MDE7550AGW Benutzerhandbuch Seite 8

O
PERATING
S S
ETTING A ENSOR
If there are no words on the touchscreen, open the door, touch any key (except OFF), or touch the screen to "wake" the
controls.
Home
timed dry freshen up
sensor dry crease removal
air fluff
favourites
(no heat)
Step 1
Select "Sensor Dry". The next screen
will be the Review Screen.
selections are
Start/Pause. If changes need to be
made, follow the next steps.
Press "Start/Pause" or
change your selections below.
options
dryness level
end chime medium
normal dry
temperature
medium
Step 4
Review Screen – This screen reviews
your selections before starting the dryer,
and allows you to choose options to
further customise
programme. You may press Start/Pause
to begin drying or press a displayed
choice to change previous selections.
Remember: As you use the touchscreen, if you feel you are lost, press Back or Home.
Downloaded from www.Manualslib.com
I
NSTRUCTIONS CONT
D P
RY ROGRAMME
dryness level
normaldry
temperature
Step 2
Dryness Level – Select "Dryness
Level" to change from the default setting
If the
("Normal Dry"). The dryness level ranges
correct, press
from least dry to driest. Select the level
appropriate for the load. The "Normal
Dry" level will be used for most loads.
crease prevent
reminder chime
Step 5
Options Screen – There are four option
choices available, touch each option to
select or deselect it:
your drying
• "Crease Prevent" - Intermittent
tumble in room temperature air for up to
two hours following the dry programme.
• "Damp Dry Chime" - Chimes when
load is damp.
• "Reminder Chime" - Chimes at the
end of the programme every 5 minutes
for up to two hours.
• "End Chime" - Chimes once when the
selected dryness level is reached.
Press "Continue" to return back to the
review screen.
manuals search engine
.
Press "Start/Pause" or
change your selections below.
Dryness
options
programme chime medium
driest drier
normal dry
medium less dry least dry
Options
end chime
medium
continue
7
Press "Start/Pause" or
change your selections below.
Temperature
options
dryness level
programme chime medium
normal dry
high medium
temperature low extra low
medium
Step 3
Temperature – Select "Tempe-
rature" to change from the default
setting ("Medium"). The temperature
settings range from extra low to high.
Select the temperature that is
appropriate for the load.
Step 6
If you are satisfied with the selections,
press the Start/Pause touchpad to
begin the programme.