in-lite FISH EYE 100 Installationshinweise Seite 8

EN
Contents
1x FISH EYE 100 (WW) 12 V / 5 W
Dimension Ø 100 mm / 3.9 inches
Dimension stainless steel ring Ø 108 mm / 4.3 inches
Recess height 86 mm / 3.4 inches
1x Easy-Lock
1x Torx key
Material
Impact-resistant polycarbonate
Stainless steel ring
Please read the following instructions before installing. You are
advised to keep these installation instructions in a safe place.
Although a 12 V system is safe, we advise you to have a qualified
electrician check the installation.
Use
Integrated atmospheric lighting suitable for illuminating plants (small
trees, ornamental trees) or as lights marking a pathway, patio, pond
edge, driveway etc.
This fixture is equipped with a 360° rotating light unit. To direct the
'Fish Eye', you must first slightly loosen the three screws of the top
plate. Turn the eye to the desired position and then fix it in place by
tightening the screws. ATTENTION! Do not over-tighten the screws;
only tighten them enough to fix the eye in place.
Lamp
The fixture is equipped with a high-quality LED lamp. These lamps
have a long life (about 25,000 hours) and a high light output and their
power consumption and the heat produced are extremely low.
Important!
Never connect the low-voltage cable directly to a 100-240 V power
source. It is only suitable for use in combination with a 12 V low-voltage
system. This product should only be used within the in-lite system. Use
of products other than those made by in-lite will invalidate the warranty.
Enjoy the lighting in your yard.