Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Attention:
The plug must only be connected to a socket with a RCD switch.
17. Machine usage
Switch on the machine using the main switch and the electronics with the
appropriate button, and regulate the power according to the requirements.
Place the induction head on the part to be heated, switch on the power using
the button on the handle, and move the induction head according to the requi-
rements.
Switch off the electronics by pressing the button on the control panel after
use and then switch off the pump and the blower using the main switch so that
everything can cool down together.
18. How to use the machine
Turn on the main switch and the machine
will be immediately operational. If necessary,
press button 4 for 10 seconds to restart.
All LED's will switch off and will
switch on again after a short time. This time
is necessary so that the coolant can circu-
late in the unit and the lines. If the LEDs of
buttons 1, 2 and 3 fl ash, a fault is present. In this case, the device must fi rst be
restarted. If the problem continues, contact our customer service.
WWW.TOOL-IS.COM
35
Werbung
