Operation; Maintenance; Warranty - Hoshizaki IM-240DME Installationsanleitung

ENGLISH
* Keep the Scoop clean. Clean it by using a neutral cleaner
and rinse thoroughly.
* Close the Door after removing ice to prevent entrance of
dirt, dust or insects into the Storage Bin.
2. The use of any electrical equipment involves the observance
of some fundamental rules. In particular:
* Instances of high humidity and moisture increase the risk of
electrical short circuits and potential electrical shocks. If in
doubt, disconnect the icemaker.
* Do not pull the power cord in order to disconnect the
icemaker from the feed network.
* This appliance is not suitable for unsupervised use by
young children or aged or infirm persons.
3. All parts are factory-adjusted. Improper adjustments may
result in failure.
4. If the unit is turned off, wait for at least 3 minutes before
r e s t a r t i n g t h e i c e m a k e r t o p r e v e n t d a m a g e t o t h e
Compressor.

1. OPERATION

The installer will normally commission the icemaker to start the
automatic icemaking process. To ensure continuous operation, make
sure that:
* The water supply tap is on, and
* The icemaker is plugged into the power supply.
2. PREPARING THE ICEMAKER FOR LONG STORAGE
) Unplug the icemaker or disconnect the power supply.
2) Close the water supply tap, and remove the Inlet Hose.
3) Remove all ice from the Storage Bin, and clean the Bin.
4) Ask for draining of the icemaker by professional qualified personnel.
III. MAINTENANCE
1. CLEANING
WARNING
. Before carrying out any cleaning or maintenance operations,
unplug the icemaker from the electrical supply network.
2. Ask a trained service person to clean and sanitize the
icemaker water system at least twice a year and to check
and clean the Condenser at least once a year.
3. This appliance must not be cleaned by use of a water jet.
[1] Machine and Bin Exterior
Wipe the exterior at least once per week with a clean, soft cloth. Use
a damp cloth containing a neutral cleaner to wipe off grease or dirt.
[2] Scoop and Storage Bin Handle Cleaning/Sanitisation (Daily)
) Either mix 3 litres of water with  ml of 5.25% sodium hypochlorite
solution in a suitable container, or the recommended Hoshizaki
sanitiser as directed.
2) Soak the Scoop in the solution for more than 3 minutes. Rinse
thoroughly, and shake to remove surplus liquid.
Note: Using a cloth to dry may re-contaminate.
3) Use a neutral cleaner to wash the Storage Bin Handle. Rinse
thoroughly.
4) Soak a clean cloth with the sanitising solution, and wipe the
Handle. Use fresh water and a clean cloth to rinse/dry.
[3] Storage Bin Interior Cleaning/Sanitisation (Weekly)
) Open the Storage Bin Door, and remove all ice.
Note: Hoshizaki recommends various types of Storage Bin for
the icemaker which vary in size and design. The following
instructions are therefore for general guidance only.
2) Wash the Bin liner, Ice Deflector and Door inner surface with a
neutral non-abrasive cleaner. Rinse thoroughly with a clean cloth
and fresh water.
3) Either mix 5 litres of water with 8 ml of 5.25% sodium hypochlorite
solution in a suitable container, or the recommended Hoshizaki
sanitiser as directed.
4) Soak a clean sponge or cloth with the solution, and wipe the Bin
liner, Ice Deflector and Door inner surface.
5) Rinse thoroughly with fresh water and a clean cloth to wipe off the
solution. Close the Bin Door.
Note: Some solutions may cause damage to the Bin liner surfaces
or corrosion on the metal parts. Always rinse the sanitiser
unless directed otherwise by Hoshizaki guidelines.
[4] Air Filter (Air-Cooled Model Only)
A plastic mesh Air Filter removes dirt or dust from the air, and keeps
the Condenser from getting clogged. As the Filter gets clogged, the
icemaker's performance will be reduced. Contact an authorised
Hoshizaki service company to complete Air Filter cleaning as part of a
regular maintenance programme.
[5] Icemaking Water System
To keep the icemaker hygienic, periodic cleaning of the icemaking
water system is recommended. Always ask a trained service person
to clean the water system.
Note: . The Washing Switch on the side of the Control Box is
intended for use by service personnel only.
2. During normal icemaking operation, keep the Washing
Switch in the "ICE" position.
2. BEFORE CALLING A SERVICE AGENT
If the icemaker does not work properly or does not work at all, before
calling for service, check that:
* The power is supplied to the unit.
* The water is turned on.
For further assistance or advice, contact your local Hoshizaki service
agent.

3. WARRANTY

Hoshizaki warrants to the original owner/user that all Hoshizaki
branded products shall be free of defects in material and/or
2
Washing Switch
Control Box
Fig. 1