Rimage FireWire Producer III Serie Installationsanleitung Seite 3

4
Connect the Producer III cables.
a. Connect the
power cord
from the
Producer III
to the power
outlet.
5
Install the printer access cover.
a. With the printer access
Printer
door in the open position, Access
Door
place the printer access
cover on the Producer III
Printer
as shown.
Access
Cover
b. Slide the printer access
cover toward the front of
the Producer III, ensuring
that the tabs on the printer
access cover slide into the
slots on the Producer III
frame.
c. Close the printer access door.
d. At the back of the Producer III, turn the
knob clockwise to secure the printer
access cover.

6
Power on the Producer III.
To power on the Producer III, press
the power switch. The autoloader and
b. Connect the USB printer are powered on.
cable from the
Producer III to
the PC.
c. Connect the
FireWire cable 7
from the Producer
Activate the Rimage software.
III to the PC.
You have 30 days to activate your Rimage software. Until your
software is activated, you will be prompted to activate your
Rimage software each time you use it.
8
Learn more.
For information about submitting orders to the Producer III across a
network, refer to the Advanced Setup Guide. The Advanced Setup
Guide is installed on your control center. To access the Advanced
Setup Guide, navigate: Start > Programs > Rimage > Manuals
or visit www.rimage.com/support.html.
For information about operating and maintaining the Producer III,
refer to the Producer 7100 and Producer 8100 User Guide included
with your product.
For additional support and product information,
go to www.rimage.com/support.html.
Printer
Access
Cover
Knob
110870_A