Description Of The Appliance (Fig. 1); Using The Appliance - Kenwood VC2778-Serie Bedienungsanleitung

DESCRIPTION OF THE APPLIANCE (Fig. 1)

1 Foot-operated cord rewinder button
2 Suction power regulation
3 Foot-operated on/off switch
4 Dust bag / dust container full indicator light
5 Suction device coupling
6 Dust bag / dust container compartment
release lever
7 Dust bag / dust container compartment
8 Fabric dust bag
9 Dust container
ATTACHMENTS
Floor brush (11)
Ideal for cleaning any type of surface. Use the device on the top of the attachment to:
- retract the bristles when cleaning carpets or rugs;
- lower the bristles for smooth floors such as PVC, parquet or tiles.
Small suction device (13)
This can be used to remove dust from books or other delicate items, such as picture frames, etc.
It is suitable for cleaning upholstered furniture, mattresses, cushions, curtains, etc...
This attachment can also be fitted directly to the handle (16).
Narrow suction nozzle with brush (15)
This suction device is ideal for cleaning between the folds on fabrics, joints, corners or niches that
are impossible to reach using the floor cleaning device. This attachment can also be fitted directly to
the handle (16).
VACUMM CLEANER ASSEMBLY
WARNING: Before fitting or removing the attachments, always make sure that the vacuum cleaner
has been unplugged from the power mains.
CAUTION: This appliance can operate either using a paper dust bag, which needs to be replaced
each time it is full, or using the special plastic container, which needs to be emptied after each use.
Select the operating mode that best suits requirements.
- Fit the suction device (10) into the air inlet opening (5) and press it in until it clicks into place. To remove
it, it is necessary to press the two release buttons (12) at the same time and to pull it out (Fig. 2).
- Insert the telescopic tube (19) into the handle (Fig. 3).
- Push the slider device (18) forwards and pull the bottom section of the tube out to the required
length (Fig. 4). Then simply release the slider and the device will return to its original position.
- Fit the required attachment to the telescopic tube.

USING THE APPLIANCE

Caution: Before using the vacuum cleaner, remove all large or sharp objects from the floor to avoid
any possible damage to the cleaner itself.
10 Suction device
11 Floor brush
12 Release buttons
13 Small suction device
14 Attachment storage compartment
15 Narrow suction nozzle with brush
16 Handle
17 Manual air inlet valve
18 Slider device
19 Telescopic tube
- 9 -
EN