Setup; Microphone Holder; Antenna - Team TS-11vi Bedienungsanleitung

TEAM TS-11vi
Noise Blanker
Automatical Squelch
TX/RX S-Meter
Roger Beep
Frequency /Menu
Base the decision about the position of the TS-11vi radio and the microphone
in your vehicle on the aspect of safety and convenience. No part of the setup,
i.e. radio, microphone, cable, etc., should restrict or obstruct the driver or pas-
senger in any way at any time.
U-Bracket Holder
Mount the U-shaped bracket holder with the screws and the washers at the
best location in the vehicle.

Microphone Holder

Base the decision about the position of the microphone holder in your vehicle
on the aspects of safety and convenience. No part of the setup, i.e. radio,
microphone, cable, etc., should restrict or obstruct the driver or passenger in
any way at any time.
Mount the microphone holder with the two threading screws onto the desired
location in the vehicle.

Antenna

The antenna should be matched with the radio, otherwise a part of the trans-
mit power will be reflected in the antenna and will not be radiated. This will
reduce the range of operation.
Since the antenna is one of the most important links in the setup, the following
criterias are very important.
General :
RF Gain
Talkback
HI-CUT
Mode
TX
DCS
Key Lock
LCD
VOX

SETUP

English
Beep Sound
Emergency
CTCSS
Channel
Band
19