Installation Instructions - Climadiff CLS12H Gebrauchsanweisung

3. DESCRIPTION

4. INSTALLATION INSTRUCTIONS

Before using your thermoelectric cooler

Remove the inner and outer packaging.

Allow the appliance to rest for two hours before switching it on.

Clean the inside using a soft cloth and lukewarm water.
Installing your appliance

This device is only intended to be installed in free standing, in no case it must be installed in
a built-in or embeddable way. For a good functionality of the device it is imperative to leave
a good air circulation all around the device. We do not take responsibility for failure to
comply with the installation instructions.

Position it in a place with sufficient strength to support its weight when loaded. To ensure
that it is level, adjust the height of the feet underneath.

To get the best from your appliance with the lowest energy consumption, do not place the
appliance close to a heat source (heater, cooker, etc.), do not expose it to direct sunlight, and
do not place it in a room which is too cold.

Connect the appliance to a single socket, leaving a 10 cm gap between the back of it and the
wall and 2 cm on each side. Be careful to support it, so that it is perfectly level. (Use of a
10
16
1 Cabinet
2 Shelf
3 Cold fan
4 Cold fan cover
5 Ventilation holes
6 Leveling feet
7 Upper hinge cover
8 Glass door
9 Door gasket
Bottom hinge