Gb Toshiba Bluetooth Module Installation - Toshiba TECRA S3 Installation

TOSHIBA Bluetooth Module Installation
This sheet provides information on installing the Bluetooth module in the
TECRA S3.
This sheet is for information only. The Bluetooth module must be installed
by dealers of TOSHIBA or TOSHIBA OEM products.
Installing the Bluetooth module
1. Discharge static electricity from your body by touching a metal object,
before you handle the card.
2. Turn off the power and disconnect the AC adaptor.
3. Turn the computer upside down.
4. Remove the battery pack from the computer. For instructions on
removing the battery pack, refer to Chapter 6 in the online manual.
5. Turn the computer right side up, open the display panel and make it flat.
6. Insert a thin object into the notches of both sides of the speaker cover
and lift it out.
7. Remove two screws securing the keyboard.
Figure 1: Removing the speaker cover and two screws
Speaker cover
Screws
GB-1