Maintenance And Cleaning - Vigor V 1711 Anwendungshinweis

Safety Instruction:
Brake pistons on calliper systems with locking device
for hand brakes must not be pushed back but turned back.
Brake pistons on calliper systems without locking device for
hand brakes must not be turned back but pushed back.
Attention:
• Always consider the regulations of the manufacturer.
• Repair work on brake systems should only be executed by
qualifi ed personnel.
• Follow the safety regulations and the rules for prevention
of accidents carefully!
Contents:
16 parts, in plastic box,
consisting of:
Basic appliance and 15 adapters
Technical Data:
Air connection:
1
Air pressure: 5 – 8 bar
6. Spare Parts
• Only use the manufacturer's original spare parts.
• Unsuitable or defective spare parts may cause damage, malfunction or total failure of the
tool.
• The use of non-approved spare parts will void all warranty, service and liability claims as well
as all claims for compensation against the manufacturer or its agents, distributors and sales
representatives.
7. Disposal
• For disposal, clean tool and disassemble it according to the regulations for work safety and
environmental protection. Components can be recycled.

8. Maintenance and Cleaning

• Before executing any maintenance work, disconnect the appliance from the air supply.
• To clean the tools or its components, we recommend using cleaning solvent.
• Do not use solvents or acids, esters (organic compounds of acids and alcohol), acetone (ke-
tone), chlorinated hydrocarbons or nitrocarbonic oils to clean the tool. Do not use chemicals
with a low fl ashing point.
Oiling:
• Pneumatic tools have to be oiled throughout their whole service life.
The motor and the (ball) bearings need compressed air to power the tool. As the moisture in
the compressed air leads to rust of the motor, daily oiling of the motor is necessary. For this,
the use of an integrated oiler is recommended.
IMPORTANT:
The use of an air fi lter and an air hose oiler is recommended.
⁄ ˝
4
(Fig. 3)
13