Casals VT50REA Bedienungsanleitung Seite 5

that the moving parts are not misaligned or
jammed and make sure there are no broken parts
or anomalies that may prevent the appliance from
operating correctly.
- Keep the cutting tools sharp and clean.
- Use the appliance and its accessories and tools
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use the appliance for operations
different from those intended could result in a
hazardous situation.
- Let the appliance running with no load for 30
seconds in a safe position. If you notice serious
vibration or other defects stop the appliance
immediately. Then check the problem and /or proceed
as we describe on Anomalies and Repair clause.
Service:
- Make sure that the appliance is serviced only by
specialist personnel, and that only original spare
parts or accessories are used to replace existing
parts/accessories.
- CAUTION: There is a risk of fire if the appliance's
cleaning is not done according to these
instructions.
- Any misuse or failure to follow the instructions for
use renders the guarantee and the manufacturer's
liability null and void.
Instructions for use
Before use:
- Make sure that all the product's packaging has
been removed.
- Ensure that the voltage indicated on the rating
label matches the mains voltage before plugging
in the
appliance.
- Prepare the appliance according to the function
you wish to use:
Auxiliary Operation
- When working always use the auxiliary handle
(G).
- The depth can be set with the depth stop (H).
Thereby loosen the winged screw by turning the
auxiliary handle (G) counter clockwise.
- Set de required drilling depth.
- Tighten the winged screw by turning the auxiliary
handle (G) clockwise.
Insert a drill bit:
- To open the drill's chuck, whilst completely
switched off, take firm hold of the back part of the
chuck and turn the front part of the chuck counter
clockwise.
- Insert the drill bit, screwdriver bit, or other tool/
accessory required for the task, into the chuck. In
order to obtain a secure fastening of the bit, insert
the bit as far as you can into the chuck. Take firm
hold of the back part of the chuck and turn the
front part of the chuck clockwise until it is firmly
closed.
- In order to remove accessories from the chuck,
follow the same steps as indicated previously but
in reverse order.
Screwing, drilling/unscrewing:
- To drill or screw, ALWAYS have the direction set to
clockwise (CW).
- To unscrew, set the direction to counter clockwise
(CCW).
- The appliance should not be in use when
changing the screwing direction.
Rotation direction change:
- Do not change the direction of the rotation whilst
the tool motor is in operation.
- The appliance has a selector (D), which allows
the direction of rotation to be changed
Electronic speed control:
- The speed of the appliance can be regulated
by using the speed regulator control (A). This
function is very useful, as it makes it possible
to adapt the speed of the appliance to the
type of work that needs to be done.
- If the appliance works continuously at low