Cleaning And Maintenance - Haws SVS-1000 Bedienungsanleitung

5. Press the key "
key "+" or "-" to adjust the timer between 00:00 to 99(h):59(m). Every press with a beep sound changes 1
minute. Long press the "+" or "-", the time is changed without stop until the key is released.
6. After setting is finished, press the key "
to continuously illuminated from flashing.
7. When the set temperature is reached, the appliance will send out a long beep and the time starts to count
down.
8. Add your food into the container and let the appliance do its work. Three beeps would be heard when the
countdown is finished. The appliance will enter into standby.
9. Remove the cooked food. CAUTION: The skirt part will become very hot during working or after working,
please do not touch it unless it is cooled down completely.
10. Unplug the appliance and clean it by following the section "cleaning and maintenance".
Note:
1. During use, you can press the key "
temperature and time by pressing the key "
operation. Press the key "
flashing. The appliance will work based on the reset settings. Please note the resetting shall be finished
within 3 seconds, otherwise the resetting will be invalid and the appliance will still work based on the current
settings.
2. During use, you can long press the key "
mode.
3. This appliance is equipped with memory function, which means the appliance will work according to the last
setting temperature/time after being powered on again under standby mode. However, if the appliance is
unplugged, the memory function will not be available. The appliance will display the default temperature
"50.0" and timer "03:00" respectively after being turned on again.

CLEANING AND MAINTENANCE

CAUTION: The whole appliance cannot be put into the dishwasher for cleaning. Allow the appliance to cool down
to room temperature and then wipe it down carefully with a damp cloth and dry before storing. If the immersed
parts become greasy or need more cleaning:
1. Lock the appliance onto a container and fill the container with water to the "MAX" level indicated on the
appliance.
2. Set the temperature to 65°C.
3. Add 1/2 tablespoon non-foaming dishwashing liquid per gallon of water used.
4. Allow the water to circulate for 10 minutes after 65°C is reached.
5. Turn off and unplug the appliance.
6. When the appliance is cooled down, rinse the bottom with cold water and dry before storing.
Descaling
With frequent use, descaling should be done every month or more often in regions with hard water. To descale:
1. Lock the appliance onto a container and fill the container with water to the "MAX" level indicated on the
appliance.
2. Set the temperature to 80°C.
3. Add 1/4 cup of citric acid powder per gallon of water used.
" to have the icon "
" to let the appliance start heating. The indicator of "
" to check the set temperature and time. You can also reset the
" again after reset, its indicator will turn to continuously illuminated from
" flashing. Now you can set your desired working time. Press the
" (to have its indicator flashing) and then following the above
" to make the appliance stop working and enter into standby
- 35 -
" will turn