Setting The Odometers; Setting The Circumference And The Unit - Mavic Wintech E-BOLT Bedienungsanleitung

the

12. SETTING THE ODOMETERS

12.1 Use the left button to select screen 4 (ODO).
Hold down the right button for more than 4 seconds. The bike
number flickers. If necessary, use the left button to modify the
bike number
(1, 2 or H), then
validate with the
right button.
12.2 Then set the
odometer for the
bike selected: use
the left button
to modify the
flickering digit,
then validate and
move on to the
e
next digit with the
et
right button. When
you have set the
odometer, use
the right button to
validate.
13. SETTING THE CIRCUMFERENCE
AND THE UNIT
R
13.1 Consult the table of approximate correspondences to
check your wheel circumference (see table 13.1).
For a more precise
measurement, proceed as
follows:
- Make a mark on the tire
and on the ground at the
point of contact between
the tire and the ground.
- Do one full turn of the
wheel and mark on the
wintech-esbolt bis.indb 15 wintech-esbolt bis.indb 15
12.1
R L
4 sec.
12.2
L R
Tyre Ø Tyre
26''x1,5 2020 700Cx19
26''x1,75 2070 700Cx20
26''x1,9 2090 700Cx23
26''x2,0 2110 700Cx25
26''x2,1 2130 700Cx28
26''x2,2 2150 700Cx32
26''x2,3 2170
650Cx19 1930
650Cx23 1990
ground the place where the mark on the tire touches the
ground.
- Measure the distance (Ø) between these two points in
millimeters.
13.2 Use the left button to select screen 3 (ATM).
Hold down the right button for more than 4 seconds. The bike
number flickers and the CIR display appears. If necessary,
R
use the left button to modify the bike number (1, 2 or H), then
validate with the right button.
13.3 The default value 2105 appears, and the digit on the
extreme left flickers. Enter the distance you have already
measured (in millimeters), by modifying the flickering digit with
the left button, then validate with the right.
When you have set the
circumference, validate with the
right button.
13.4 Then use the left button to
select the distance unit (Miles
R
or Kilometers). Validate with the
right button.
If required, repeat the operation
for bike 2.
13.3
Ø
2100
2110
2130
2140
2150
2170
L R
13.1
13.2
R R
4 sec.
13.4
R L R
20/03/07 12:34:20 20/03/07 12:34:20
15