Fitting/Removing The Computer; Installing The Sensor Nut; Installing The Magnet; Installing The Batteries - Mavic Wintech E-BOLT Bedienungsanleitung

3. FITTING/REMOVING THE COMPUTER

3.1 Slide the computer onto the mount from the front until it
locks into place with an audible click.
3.2 To remove the computer, press the button underneath the
mount and slide
the computer out
towards the front of
the bike.

4. INSTALLING THE SENSOR NUT

4. Installing the Sensor nut
The speed sensor in this computer is integrated into a fixing
nut compatible with all quick-
releases on the market.
To install it, unscrew the fixing
nut on your quick-release.
Insert the quick release from the
left-hand side of your bike and
tighten the electronic fixing nut
from the right-hand side.
Adjust the tightness of the nut
so that the quick-release locking
lever can be sufficiently firmly
pushed into the CLOSE position
(if in doubt, consult your retailer
or the hub manual).
4.1 Road bike.
Once sufficiently tightened,
position the sensor towards the
rear before closing the quick-
release hub.
4.2 Mountain bike.
Once sufficiently tightened,
position the sensor towards the
top before closing the quick-
release hub.
12
wintech-esbolt bis.indb 12 wintech-esbolt bis.indb 12
2
3.1 3.2
4
4.1
4.2

5. INSTALLING THE MAGNET

5.1 Position the magnet on a spoke so that it passes opposite
either of the lever marks and at a maximum distance of
5 mm.
When used on a mountain bike, it might be necessary to use
the adjustment magnets to reduce the distance between the
sensor and the magnet. (5.2).
The magnet must be facing outward from the wheel.
5.3 Must be cut for use on profiled Zicral spokes
1
5.1

6. INSTALLING THE BATTERIES

Power supply for the computer: 1 CR2032 battery.
Power supply for the speed sensor: 1 CR2032 battery.
Only use this type of battery.
Installing the batteries:
6.1 Remove the battery cover by turning
it a quarter turn anticlockwise, using
a coin.
6.2 Insert the battery into its recess,
keeping the + side uppermost.
6.3 Refit the battery cover and close it by turning
it a quarter turn clockwise.
Do not to use excessive force, or you will
damage the unit.
Check the condition of the seal on the battery
cover each time you change the battery. Replace
the battery cover if the seal is damaged.
Always perform the above operations in a dry
place.
5.2 5.3
6.1
6.2
20/03/07 12:34:17 20/03/07 12:34:17
Ch
eff
tot
(M
Aft
ba
(in
im
de
Ba
7.
8.
8.1
S
• S
• N
• P
• T