Accessories; Stem Deflector; Extension; Side Ejector - Avdel Genesis G3 HD Betriebsanleitung

A c c e s s o r i e s
S t e m D e f l e c t o r
The stem deflector is a very simple alternative to the standard
stem collector and allows access in restricted areas. To
replace the stem collector with the stem deflector proceed as
follows:
•
Unscrew retaining nut 22 by inserting a 3 millimetre
diameter rod into one of the holes.
•
Remove retaining nut 22 and the stem collector assembly,
items 18, 19, 20, 21, 45, 62 and 63.
•
Screw the adaptor nut onto end cap 23.
•
Push the boss end of the stem deflector into the internal
groove of the adaptor nut.
•
Rotate the stem deflector until the aperture faces away
from the operator and other person(s) in the vicinity.
E x t e n s i o n
Fitted between the tool and the nose assembly the extension
gives an extra reach of 76mm, ideal for use in deep narrow
applications.
•
To fit the extension, remove any nose assembly
components.
•
Screw the inner extension to jaw spreader housing 1.
•
Screw the outer onto head assembly 4.
•
Fit the nose assembly onto the extension.
S i d e E j e c t o r
Fitted between the tool and the nose assembly, the side ejector
forces fastener stems to eject at the front of the tool and gives
an extra reach of 90mm.
It cannot be used in conjunction to a swivel head. Select the
correct part number (below right) according to the stem diameter
of the fastener.
For greater ease of use, it is recommended that the stem
collector or deflector is replaced with safety cap part number
71210-20201 as used with swivel heads. See page 14 for fitting
instructions, but note that the stop nut is not fitted in this case.
•
To fit the side ejector, remove any nose assembly
components.
•
Remove the socket cap screw from the side ejector.
•
Screw the inner extension onto jaw spreader housing 1.
•
Screw the outer casing onto head assembly 4.
•
Replace the socket cap screw securing with Loctite
Screwlock 222, part number 07900-00371.
•
Screw the nose assembly onto the side ejector.
Item numbers in bold refer to the general assembly drawing and parts list on pages 22-23.
12
STEM DEFLECTOR
ADAPTOR NUT
71210-20101
STEM DEFLECTOR: 71210-20100
INNER
71210-20301

EXTENSION: 71210-20300

Part number: 07498-00900
for fasteners with a stem larger than 3.1 mm (
OUTER CASING
INNER
EXTENSION
07340-00342
OUTER
71210-20302
1 / ") Ø
8
8-32 x / " SOCKET
1
4
CAP HEAD SCREW