Installation - Tripp Lite PDUMH15 Benutzerhandbuch

Installation

Note: The illustrations may differ somewhat from your PDU model.
1 Determine Installation Configuration. The PDUs covered by this owner's manual support
these installation configurations: 2U, 1U and 0U rackmount; wall-mount and under-counter.
See below for installation configurations pertaining to your specific model. Choose a
configuration and follow the installation instructions in the appropriate section of Step 1
before proceeding to Step 2.
Note: Regardless of installation configuration, the user must determine the fitness of hardware and
procedures before mounting. The PDU and included hardware are designed for common rack and rack
enclosure types and may not be appropriate for all applications. Exact mounting configurations may vary.
2U Rack Installation. Attach the
1-1
included brackets to the side of the
PDU with the included screws
installing the brackets, position the
PDU in the rack and install four user-
supplied screws through the unit's
brackets and into the rack rails
1-2 1U Rack Installation. Attach the PDU
to the rack by inserting four user-
supplied screws
mounting brackets
mounting holes of the rack rail as
shown.
0U Rack Installation. Part 1: Remove
1-3
the screws
C
brackets to the PDU, change the
orientation of the brackets as shown
and reattach the brackets. Use only
the screws supplied by the
manufacturer or their exact equivalent
(#6-32, 1/4" flat head). Part 2: Attach
the PDU vertically by inserting two or
more user-supplied screws
the PDU mounting brackets
into mounting points in the rack or
rack enclosure.
18-11-317-933059.indb 3
A . After
.
B
A through the PDU
B and into the
attaching the mounting
A through
B and
1-1
B
B
1-2
B
B
1-3
3
A
B
A
A
A
C
C
2/20/2019 4:26:37 PM