Removing The Source Unit; Trim Ring Installation - Clarion CZ301E Benutzerhandbuch & Installationshandbuch

Method B
1. Insert this unit directly to the opening of the
dashboard.
2. Place M5×6 cylindrical screw through the
holes of the mounting frame located inside
the opening to holes of the unit and fasten
the screws to left & right.

Trim ring installation

Attach the trim ring around the front panel.

6) Removing the Source Unit

Disassemble trim ring
1. Push the trim ring to right and pull out the
right part.
6
2. Push the trim ring to left and pull out the
left part.
Disassemble the unit
1. Switch off the power.
2. Remove the panel.
3. Remove the trim ring.
4. Insert the removal keys straight back until
they lock, then pull the unit out.
5. Disconnect all the wires.
26