Programme Selection - Hitachi 26H8L02-G Bedienungsanleitung

LCD TV and Operating Buttons (Depending on the model)
FRONT and REAR VIEW
Switching On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC 50 Hz. Then the standby LED lights up (The led will blink during the standby On/Off).
To switch on the TV from standby mode either:
Press the " " button, CH or CH or a numeric button on the remote control.
Press the middle of the control switch right side of the TV. The TV will then switch on.
Note: If you switch on your TV via CH or CH
watching last will be reselected.
By either method the TV will switch on.
To Switch the TV Off
Press the " " button on the remote control or hold the control switch on the Tv until shut down , so the TV will switch to standby
mode.
To power down the TV completely, unplug the power cord from the mains socket.
Note: When the TV is switched to standby mode, standby LED can blink to indicate that features such as Standby Search, Over Air
Download or Timer is active.
Operation with the Buttons on the TV
Volume Setting
• You can move the control switch upward or downward for changing the volume. To increase volume, please move the switch upward.
Move the switch downward to decrease the volume. A volume level scale (slider) will be displayed on the screen.

Programme Selection

• First press the control switch once to change channel. You can move the switch upward to select the next programme or move it
downward to select the previous programme.
AV Mode
• Press the control switch consecutively until the source OSD is displayed on the screen.
01_MB6X_[GB]_HITACHI_ORTAK_IB_50214635.indd 7 01_MB6X_[GB]_HITACHI_ORTAK_IB_50214635.indd 7
Control switch VIEW
buttons on the remote control or on the TV set, the programme that you were
English - 7 -
Control Switch
1. Up direction
Down direction
2.
Programme/Volume / AV / Standby-
3.
On selection switch
Note:
Press the middle of the switch to switch
on the TV.
To switch to standby mode, press the middle of
the switch and hold about a few seconds.
Move the switch, upward or downward to
change the volume.
To change channels, press the middle of
the switch once (Position 3) and then move
upward or downward.
Press the middle of the switch once more,
source OSD will be displayed. To select
desired source, move the switch upward or
downward and release.
Main menu OSD cannot be displayed via
control buttons.
10.02.2012 17:52:45 10.02.2012 17:52:45