Kärcher 2.643-381.0 KM Medium Bedienungsanleitung Seite 14

3.8 Attaching the holder to the device
Figure 11: Holder inserted and secured
3.9 Test
3.9.1 U.S./Canadian appliances only
3.9.2 Checking blink codes
1 2
Figure 12: For better visibility, the illustration is shown with-
out the plugged-in 24-pin plug
14
3
4
-
EN
1 Support
Note
Do not insert and secure the holder prior to checking the
blink codes (see following chapter).
Slide the holder into the recess and secure it by means

of the accompanying screws 5x16.
Then attach the label enclosed next to the type plate on

the sweeper.
Prior to fastening the retaining plate, the functionality must
be checked by means of the LED blink codes of the TCU.
1 LED red (PWR)
2 LED green (GPS)
3 LED green (WIFI)
4 LED yellow (COMM)
Connect battery.

Turn on the machine.

Check the LED blink codes based on the following ta-

ble.
Close the control and tighten the screws.

Switch on the device and leave it on for at least 5 min-

utes.
6