Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.6
Securing the fleet management module on the holder
Figure 8
3.7
Attaching the antenna to the fleet management module casing
Figure 9: Antenna cable
Figure 10: Completely installed and connected fleet man-
agement module
Position the Fleet Management module on the tin plate.
Screw in M4x6 screws and tighten them.
Max. torque 1 Nm.
1 Cable connector
Coil the antenna cable as shown and secure it with ca-
ble ties.
1 24-pin plug
2 Antenna
3 Adhesive pad, double sided
4 Fleet Management module
5 GPS plug, blue
6 COMM plug, purple
Degrease the glued surface on the antenna and the
Fleet Management module with the supplied cleaning
cloth.
Attached the adhesive pad at the centre of the anten-
na's bottom side.
Note
The bottom side is opposite of the side with the label
"FACE TO SATELLITE"
Turn the antenna with the label "FACE TO SATELLITE"
so that it faces upwards.
Glue the antenna onto the fleet management module
as shown; type plate and marking of the LEDs must still
be readable.
Insert the antenna plug into the Fleet Management
module. Connect the plug and socket of the same
color.
Fasten the antenna cable to the holder using a cable
tie.
Insert the 24-pin plug of the supplied cable harness into
the Fleet Management module.
5
-
EN
13
Werbung
