Network Setup - Wiseup WIFI31 Handbuch

while the red one keep flashing, meaning the camera's WIFI signal is ready.
3.3. Charge the camera by connecting it to an AC outlet using the included power adapter and
USB cable. It will take 4 hours to obtain a full charge.
3.4. If you want the camera to work 7/24 hours, keep it connected to an AC outlet using the
included power adapter and USB cable.
IV. Network Setup
4.1. Install the "BVCAM" APP on your Smartphone or Tablet PC.
For Android, iPhone and iPad users, please scan the QR code to download the "BVCAM" APP.
4.2. P2P Connection Setup (LAN Mode)
4.2.1. Go to the WIFI or WLAN Setting page on your phone or mobile device, connect to the
camera's WIFI signal named "CM*****". Wait for the WIFI to be connected and your phone
status bar will appear WIFI symbol as below:
[Note]:
If the camera's WIFI signal cannot be found after a long time, please recharge the camera or
reset it (See VIII).
4.2.2. Run the "BVCAM" APP.