Desoutter FCT serie Handbuch Seite 10

Product Instructions
Spare parts
Exploded views and spare parts lists are available at https://www.desouttertools.com/service/spare-parts.
The use of spare parts other than those originally supplied by the manufacturer may result in a drop in performance or in
increased maintenance and level of vibration and in the full cancellation of the manufacturer's liability.
Related products
•
Delta 1D, 6D or 7D data analyzer (minimum firmware version 2.8x)
•
ELRT (E-pulse electric pulse tools)
•
DeltaQC Software (programming and traceability of tests) - (minimum software version 4.3.x)
•
Cables
Oil bath removal
Follow the instructions below to remove the oil bath for cleaning/discharching of the oil:
1. Make sure the FCT screw is slightly loosen, otherwise the nutsert/trasducer connection is under load and it
will be impossible to remove the locking pin.
2. Using a flat screwdriver, remove the blind plugs protecting the locking pin to gain access to the inner axis:
3. Insert a M5 screw into the locking pin housing and use it to pull out the locking pin:
01/2020 10 / 212