Set Limit Values - PCE Instruments PCE-GM 75 Bedienungsanleitung

Print graphics
The currently displayed graphics can also be printed.
A click on the icon opens the "Print" dialogue.
Save graphics
To save the currently displayed graphics, click on the
6.6

Set limit values

For each session, a limit mode and the respective limit values can be set which will be considered
when the series of measurements is saved via the
By using limit values, deviating readings will be highlighted in the chart by red, bold font and in
the graph by red horizontal lines.
To set the limits, right-click on the list in the lower part of the window and select "Limit values". A
dialogue will then open where the modes and limit values can be defined. The following modes
can be selected:
6. "Off"
The limit values of the series of measurements are deactivated.
7. "Upper limit"
An upper limit can be defined. Gloss values above the "upper limit" are outside the
valid range.
8. "Lower limit"
A lower limit can be defined. Gloss values below the "lower limit" are outside the valid
range.
"Outside"
9.
An upper and lower limit can be defined. Gloss values outside the set range are
outside the valid range.
10. "Within"
An upper and lower limit can be defined. Gloss values within the set range are outside
the valid range.
icon.
icon.
© PCE Instruments
19