GBS ELETTRONICA Puma Betriebsanleitung Seite 7

3. It will eixt the learning mode if you don't press any key in
30 seconds .
4. You can press SET and 4 together to delete all buttons you
have learnt under the device button, the LED
will flash 2 times to confirm it.
5. If the memory is full, LED blink 4 times then quit for
learnning.
6. The last singal learnt will overwrite the previous signal.
7. About 100 commands can be stored in this remote control
and about 40 commands can be learnt for one
device.
Other Functions
A. Display the Device Code:
The device codes, which has been set up in your new remote
control, can be called up
as following:
1. Press the SET key and hold it down, now actuate number
key 1 to display the 100th position of the 3-
digit code. Count the numbers when the LED flashes. If the
LED doesn't flash, that means the digit is
ZERO.
2．Similarly, press the SET key and hold it down, at the same
time actuate number key 2 to display the
10th position of the 3-digit code.
3．Press the SET key and hold it down, at the same time
actuate number key 3 to display the 1st position of
3-digit code.
Example for Code 108:
1. Press SET and ―1‖
LED flashes 1 time.
2. Press SET and ―2‖
LED flashes 0 times , no flashes.
3. Press SET and ―3‖
LED flashes 8 times.
B. Volume lock
This function makes you very convenient when you only use
one device to adjust volume. For example,
you may use your amplifier as your main volume control, then
you can use this function to fix the volume
and mute key to AMP, no matter which device you used (even
you use TV1, DVD, VCR etc), the volume
and mute key on remote control still control the volume and
mute of your amplifier.
1. Press the device button which you want to lock. E.g. AMP