winefit Cubo Bedienungsanleitung Seite 59

ENGLISH
Insert a new GAS BOTTLE GASKET [GUAR0002] onto the GAS BOTTLE FITTING PIN
[RAC0011]. Using needle-nose pliers, insert the fitting + gasket assembly in its seat. Screw
down the gas bottle fitting pin using a 4-mm flat blade screwdriver. Screw down completely,
until the pin no longer turns.
Switch on Winefit . Insert a new gas bottle and screw it down onto the fitting; carry
out this operation accurately and rapidly.
NOTE: FOR CORRECT BOTTLE TIGHTENING, screw the gas bottle down into its seat
until the red LED goes out. Once the red LED has gone out, rotate the bottle
about 1/8 turn more. WARNING: screwing down by more than 1/8 turn may damage the
gas bottle gasket.
Close the gas bottle cover.
59